Phytosanitary Certificate Cambodia May 2026

Cement Based Adhesive

Monneli Arredo Colla

Cementitious Adhesive for Natural & Artificial Stone

Uses
ARREDO COLLA is used as an adhesive for fixing internally and externally natural or artificial stone, on both walls and floors. It can be used also for fixing of the following:
All types of ceramic tiles
Vitreous mosaic
Klinker tiles
Porcelanized gres
Single-fired tiles and low porosity materials
Tiles on top of old ceramic floors, marble or natural stones
back to Tile Adhesives
Technical Information
Product Description

A powder grey adhesive for natural and artificial stone. It has a base of special binders combined with selected aggregates of a suitable granulometric size and special additives. ARREDO COLLA has a rapid setting and hydration time which prevent vertical slipping, it is a single component and therefore easy to apply by simply adding water.

Advantages
  • Fast-Setting
  • Vertical slip resistant
  • Easily workable
  • Water resistant
  • Eco-friendly
  • Formulated to suit Middle East condition
Compiliance Standard
  • European Directive UEATC
  • BS 5980 – 1980
  • DIN 18156 – 2nd part
  • ANSI A 118.4 – 1992
Packaging, Coverage / Consumption

Packaging:

ARREDO COLLA is supplied in 25kg bags.

 

Consumption: 

From 4 - 8 Kg / m² according to the type of support and stone.

Shelf Life & Storage

Storage:

Store in dry covered place in the original closed bags

 

Shelf life:

12 months if stored as recommended.

Colors
Grey or white
Technical Properties
PROPERTIES RESULTS
Appearance  Powder
Color  Grey or white
Density  1.7 kg/L
Flexural strength  6.5 N/mm2
Compressive strength  19 N / mm² 
Adhesion strength 1.8 N / mm²
Vertical sliding None
Water resistance Excellent
Aging resistance Excellent
Flexibility Very good
Open time at 25ºC 25 minutes
Grouting After 24 hours
Full strength After 15 days
Inflammability No
Service temperature From  -50C to +800C
All values are subject to 5-10 % tolerance

Here’s a short story based on the phrase Mara leaned over the wooden crate, her flashlight tracing the grain of the polished mango wood. Inside, sixty carved Buddha figurines stared back with serene, empty eyes. They were destined for a gallery in Lyon, France. But first, they needed a soul—a piece of paper that cost $15 but could kill a $15,000 deal.

“It’s been kiln-dried at 120 degrees,” Mara insisted.

“Suspicious how?” Mara’s palms dampened.

Tomorrow was Pchum Ben, a religious holiday. Nothing would move for three days.

The wood was alive.

“System says… your wood is suspicious ,” Sophea said, not looking up.

Mara closed her eyes. The certificate wasn’t a lie—it was a prayer. And in Cambodia, sometimes that was the only export that cleared customs.

Powderpost beetle.

Additional Information
Health & Safety

ARREDO COLLA is a cement-based product. During application, wear appropriate protective clothing, goggles, gloves and respiratory equipment if necessary.

In case of contact with skin, rinse with water and again wash thoroughly with soap and water. In case of contact with eyes, rinse with plenty of water and seek medical advice accordingly.

If ingested, obtain medical attention immediately. Do not induce vomiting.

Important note

The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updates on regular basis. It is the user’s responsibility to obtain the latest version.

additional materials
Fast Download
Technical Properties Sheet
download (*.pdf 0.32Mb)
OTHER PRODUCTS
More Products from this section
Monneli Adercol

Two Component Fast - Setting Cementitious Tile Adhesive

Monneli Elastokol

Synthetic Latex Additive for Tile Adhesive phytosanitary certificate cambodia

Monneli Maxicol

Polymer Modified Floor Tile Adhesive Up To 15 mm Thick Mortar Here’s a short story based on the phrase

Monneli Maxicol T50

THICK BED TILE ADHESIVE FOR INTERIOR & EXTERIOR USE But first, they needed a soul—a piece of

Monneli Neofil F10

Adhesive & Grout for Glass, Ceramic Marble Mosaics

view more
RANDOM PRODUCT
Monneli Betopoxy 200

Low Viscosity Epoxy Injection Resin

Uses
BETOPOXY 200 is used for the following:
Structural restoring
Consolidating of damaged concrete for beams, pillars
Cement screeds cracks sealing
Vertical and oblique anchorage with high pull out resistance, etc.
Injecting into concrete and masonry cracks
To seal and bond cracks widths between 0.2 to 8 mm
Contact us
Choose a location
P.O. Box: 123808, Dubai
Toll: +971 4 8803488
Fax: +971 4 8803450
Site Map