Wire Derating Chart -

That’s the new maximum before insulation damage. But the breaker is 20A, so the circuit is limited to 20A anyway.

At 55°C ambient, the factor is .

However, if the mixer draws 16A continuously (more than 3 hours), the wire must be derated again by 125% — but here, 16A is fine. But Alex realizes: — because the breaker is thermal and also affected by ambient heat. 4. The Multiplier Trap Alex also has four current-carrying conductors in the same conduit (not just two). Table 310.15(C)(1) says: 4–6 conductors → derate by 0.80. wire derating chart

Multiply the wire’s original 90°C ampacity (30A for 12 AWG) by 0.71: That’s the new maximum before insulation damage

Use the chart, or rewire the fire later. Find wire’s 90°C column ampacity → multiply by ambient temp factor → multiply by bundling factor (if >3 CCCs) → result must be ≥ load + 125% if continuous. If not, go up one wire gauge. However, if the mixer draws 16A continuously (more

| Ambient Temp | Adjustment Factor for 90°C-rated wire | |--------------|----------------------------------------| | 21–25°C | 1.00 | | 26–30°C | 0.96 | | 31–35°C | 0.91 | | 36–40°C | 0.87 | | 41–45°C | 0.82 | | 46–50°C | 0.76 | | | 0.71 | | 56–60°C | 0.65 |